Epoxy Coating in Columbus, OH

For epoxy floors in Columbus, Concrete Polish and Epoxy Ohio coats garages, basements, shops and restaurant kitchens for homes and businesses citywide. Road salt from I-71 and I-70 ends up on a lot of slabs here, so we moisture test, grind the surface and then lay down a flake, metallic or polyaspartic system that holds up to brine. The estimate is free and the quote comes in writing.

Not when the slab is prepped right. Hot tire pickup comes from thin coatings rolled onto smooth, unground concrete. Diamond grinding, a bonding primer and a full-thickness body coat under a durable topcoat keep the floor locked down when warm tires sit on it.

It can be, with the right texture. A kitchen system gets an anti-slip aggregate in the topcoat and a resin rated for hot water and grease. Coved edges at the walls keep mop water out of corners. You end up with a floor that cleans quickly and grips under wet shoes.

Flake is the most forgiving choice for an older detached garage. The chips hide uneven spots, dirt and salt residue, and the texture adds grip. Metallic looks striking in a finished room but shows every flaw. Solid color is clean and simple, and it works well in a workshop where you want dropped parts easy to spot.

Plan on a few days before cars. You can usually walk on the floor within a day, but cooler slab temperatures slow the cure, so fall jobs may need a little extra time before tires roll in. You get the exact schedule for your products and conditions before the crew leaves.

Yes, with an industrial system. Forklift aisles need high-build epoxy at real thickness plus a polyaspartic or urethane topcoat, and control joints should be filled so wheels don't chip the edges. Striping and safety zones can be built into the coating during the same project.

Yes. The failed kit coating gets ground off completely along with any loose material, then the slab is repaired and coated with a full multi-layer system. Peeling usually means the kit went over smooth concrete with no grinding, so proper prep is the real fix.

Square footage is the starting point, then slab condition. Cracks, salt pitting, old coatings and moisture all add prep time. The finish matters too, since metallic takes more labor than flake. You get a free on-site measurement and a written quote, so there's no guessing.

It often helps the house show better. A clean flake floor makes a garage look finished in listing photos and tells buyers the home was cared for. Neutral flake blends appeal to the most people, and the project is smaller than most remodels.

It depends on the moisture test. Many older basements test fine for coating, and slabs with higher readings can get a moisture-tolerant primer. Active leaks, seepage at the walls or standing water need to be fixed first, because no coating will hold over running water.