Concrete Polishing & Epoxy Flooring in Johnstown, OH

The best time is after drywall and paint but before you move in, once the slab is at least about 28 days old. The garage is empty then, so the job goes faster. Builders sometimes allow an owner's contractor before closing, so ask yours about access.

Yes. Old paint gets ground off, cracks are filled, and the slab is moisture tested. Older basements often run damper, so a moisture-tolerant primer may go down first. Then you choose a solid color epoxy or a ground-and-sealed finish. Low ceilings are rarely a problem for the equipment.

Yes, polish before fixtures and shelving if you can. An empty floor goes faster and gets an even finish edge to edge. Polishing needs no cure time, so you can move in right after. If fixtures are already set, the work can be done in sections.

Once it's cured, dust just sits on top and sweeps off. During the install, doors stay closed so dust stays out of the wet coating. With so much building nearby, a flake finish is the best at hiding tracked-in dirt between cleanings.

Epoxy is usually the better pick for repair bays. It seals the slab against oil, brake fluid and coolant, and a light color makes dropped parts easy to spot. An industrial high-build system with a chemical-resistant topcoat lasts longest. Polished concrete can work in the showroom or office.

Usually it's worth doing. Most long cracks are shrinkage cracks that stopped moving years ago, and they get filled and coated over. If one side sits higher or the crack keeps growing, the slab is still shifting. That gets flagged at the estimate before you spend anything.

Concrete Polish and Epoxy Ohio polishes warehouse and flex building floors in and around Johnstown, where suppliers and service businesses keep building on bare slabs. Polished concrete gives new space a finished floor from day one with very little upkeep. Our in-house crew grinds, densifies and polishes, working out of the office at 5605 Westerville Rd in northeast Columbus.

Flake floors have some texture, so they're less slick than smooth solid coatings. For more grip, a fine anti-slip grit can go in the topcoat. That's helpful where a dog comes in wet, since paws need traction too, and the floor still mops clean.

Usually the tile comes up first. Epoxy over tile would follow the grout lines and fail if a tile loosens. After removal, the adhesive is ground off and the slab is repaired and coated. Old black mastic should be tested before grinding, since some older adhesives contain asbestos.

Sweating is usually condensation from humid air on cool concrete, so a dehumidifier is the first fix. A coated floor makes moisture easier to see and wipe up, and it stops dusting. A moisture test still comes first to rule out water coming up through the slab.